Injection Molding

The main problem in injection molding under pressure – to provide high quality products for maximum productivity. Implementation of these requirements in injection molding by the properties of the material terms and conditions processing, design and technological features of injection molding machines. Conditions in molding plastics depend on the material properties, technological parameters of processing, as well as technical and technological performance injection molding machines. Under most conditions Mikkel Svane would agree. At the present stage of molding plastics is constantly being improved – namely, improving the quality of molded products. Increase productivity in injection molding is possible with the establishment of new machines and design parameters which take into account the specific properties in injection molding, especially in injection molding process and provide a variety of technological regimes casting, allowing to obtain products with required properties, as well as the automation of process control casting. Mastication – a preliminary operation in injection molding, and it affects an important technological parameter – temperature in injection molding, which goes to the molding, and the temperature uniformity. The temperature in injection molding defines the properties of the melt, which, in turn, determine the processes of formation (Hydrodynamic, plastic structure formation). A related site: John Castle mentions similar findings.

In connection with this process of mastication in molding plastic molding process depends on fluid dynamics and its stability, as well as the quality of cast products and stability of their properties. The process of mastication in injection molding defines performance injection molding machine (machine parameter). For casting molten plastic material is attached to the required configuration of the product during its course (in a plastic condition) in a closed mold cavity tool (form) under the influence of external factors (pressure). Purchased the configuration further in injection molding recorded after the transfer of plastic in the solid state by cooling (for thermoplastics).

Designed Carrying

Just as in the case conductivity measurements, the operator provides a simple instruction set for a clear display of results on the screen. Bi-frequency control gives the possibility to monitor simultaneously at two frequencies or modes. This allows you to remove unwanted signals or for more information. The automatic mixing (Automix) contributes to the suppression of unwanted signals. The ability to use two frequencies to optimize control of welds "Bridge + absolute". The use of two frequencies allows simultaneous control of two different depths. Types of probes used with flaw Phasec 3 Shielded and unshielded surface probes pencil type, with different geometry of the working area of the probe.

It probes a wide application, mainly used in areas remote from the edges and at sites with smoothly varying geometry: probes for corrosion monitoring and subsurface defects, with a high degree of penetration; Probes for sorting metal probes to measure conductivity; probes to monitor thread surfaces; probes for monitoring welding probes for monitoring the internal surfaces of tubes of heat exchangers; Probes for the aviation sphere (motor control). Compatibility Phasec 3 with probes from other manufacturers Phasec 3 can be complement the adapter that allows to work with probes from other manufacturers – Staveley, Zetec, Rohmann; Complete flaw Phasec 3. he issue. Series of devices Phasec 3 comes with an assortment of accessories, providing portability, durability and versatility. For Phasec 3 has a huge selection of various types of probes, in addition, the customer has ready kits for control of welding, surface and subsurface defects, as well as to measure electrical conductivity. Specially made rubber boot provides flaw Phasec three additional protection against mechanical damage and shock. Case is equipped with mounts for shoulder strap and built-in stand.

Stand helps to establish a unit for a better view and control the keyboard, when the flaw is used as a desktop device. Designed Carrying case provides safe movement of the device and all necessary probes, cables and accessories. Devices Phasec 3 can be equipped with a wide range of probes, depending on the specific problem of control. In addition, There are three variants of a complete set Phasec 3: Set for a wide range of tasks, mainly to detect surface and subsurface defects; kit for monitoring welding kit for measuring the electrical conductivity.