Just as in the case conductivity measurements, the operator provides a simple instruction set for a clear display of results on the screen. Bi-frequency control gives the possibility to monitor simultaneously at two frequencies or modes. This allows you to remove unwanted signals or for more information. The automatic mixing (Automix) contributes to the suppression of unwanted signals. The ability to use two frequencies to optimize control of welds "Bridge + absolute". The use of two frequencies allows simultaneous control of two different depths. Types of probes used with flaw Phasec 3 Shielded and unshielded surface probes pencil type, with different geometry of the working area of the probe.
It probes a wide application, mainly used in areas remote from the edges and at sites with smoothly varying geometry: probes for corrosion monitoring and subsurface defects, with a high degree of penetration; Probes for sorting metal probes to measure conductivity; probes to monitor thread surfaces; probes for monitoring welding probes for monitoring the internal surfaces of tubes of heat exchangers; Probes for the aviation sphere (motor control). Compatibility Phasec 3 with probes from other manufacturers Phasec 3 can be complement the adapter that allows to work with probes from other manufacturers – Staveley, Zetec, Rohmann; Complete flaw Phasec 3. he issue. Series of devices Phasec 3 comes with an assortment of accessories, providing portability, durability and versatility. For Phasec 3 has a huge selection of various types of probes, in addition, the customer has ready kits for control of welding, surface and subsurface defects, as well as to measure electrical conductivity. Specially made rubber boot provides flaw Phasec three additional protection against mechanical damage and shock. Case is equipped with mounts for shoulder strap and built-in stand.
Stand helps to establish a unit for a better view and control the keyboard, when the flaw is used as a desktop device. Designed Carrying case provides safe movement of the device and all necessary probes, cables and accessories. Devices Phasec 3 can be equipped with a wide range of probes, depending on the specific problem of control. In addition, There are three variants of a complete set Phasec 3: Set for a wide range of tasks, mainly to detect surface and subsurface defects; kit for monitoring welding kit for measuring the electrical conductivity.